5050 4Pin RGB LED Strip Connector Kit - Includes 10x T Shape Connectors, 10x LED Strip Jumper, 10x L Shape Connectors, 10x Gapless Connectors, 20x LED Strip Clips, 20x 4 Pin Male to Male Connector

This kit contains everything you need to cut & join led strip lights to varying lengths. I’ve been doing a game room project with led strip lights & I needed something to allow me the ability to put varying lengths at different places. And if you have used these lights you are well aware of two things; they tend to roll back from whatever surface you stick them to & they don’t handle any attempt to bend them around a surface. That’s where this kit comes in handy.It includes more than enough clips & fasteners to get the job done. The directions can be a little vague here on the product page. One recommendation I have is to gently lift the conductor pins inside the joining clips. This makes attaching the various lengths of strip much much easier. Look at the photos I included for reference. I found a small pairing knife was very effective for this task. And don’t worry. Once you snap the cover back down it pushes the conductors back into place & it forms a strong connection. I also found that using the little screw clamps really helped take resistance off the lights & joining wires so they adhered to surfaces much better.That’s really all there is to it. Take your time & enjoy the results.

The media could not be loaded.  I purchased these because I had a fairly complex design and didn't want to hand-solder wire jumpers. As it turns out, these connectors weren't making consistent connections, so I wound up soldering them. It was still faster than cutting, stripping, and tinning a ton of 24 gauge wire jumpers. The "T" connectors are the worst - I didn't find a single one that made consistent connections. The "L" and the straight-thru connectors were mostly okay. The most reliable were the wired jumpers. But in the end, I decided to not risk failure so I soldered everything. It takes a fine-pitch tip (like the kind you'd use for surface-mount ICs), some flux, and a steady hand. I then added heat-shrink to protect the connections from moisture and short circuits.

Comes with every single connector you need connect 5050 lighting strips. The kit can be used to connect multiple single 5M strips or to split a single strips into two strips i different directions. Have been using is for 2 weeks+ and it is working great. Very easy to use and connect strips.This is a good product and I highly recommend friends or family give it a try.

This kit has all I need to complete my project. Just watch the T connection because the are opposite on the other side. So they go in +,r,g,b comes out b,g,r,+. Not a problem as long as you are aware, but good have been noted in the packaging

Ii wish the clips held the lights in alittle bit better..if you leds have a ribbet coating on them you need to remove it to have the clip lock..1 star for weatherproof because they are not weatherproof.. it tells you tgar in the description.. over all a good product.

First opening these had my finger literally bleeding, but besides that, the connection is not strong enough for any strip that has any thickness to it. The wires worked fine, but none of the connectors held tight enough to use the L or 3 way connectors.

First, there is no way to stick those up. You have to buy that. Second, I don't have them were it is wet. So, I can't really rate that. Once you get the hang of inserting the ends in, it is easy.

Loved the product. I’m using it for indirect lighting behind crown molding. Coupled up with the track diffusers I also bought , should be amazing !! Tested everything out and works just as I hoped for . Thanks so much !!