2.4G 4CH/5CH/6CH/7CH Mini Receiver Support DSM2/ DSMX Protocol Built-in Brushed/Brushless ESC Regulator (RX244)

I was expecting the unit to be small but holy sweet mother of Myron Reducto this thing is TINY! I did order with it some equally tiny cable leads that I would solder some normal full sized jst compatible ends to cause this was going into a scx24 build and its been working perfectly with my original DX6iThere is also a qr code on the little bag the receiver comes with that gives you a manual as well that can be helpful in making sure you get your wiring to it right as well.

I am using this micro receiver in a Guillow Supper Cub 95. At approximately 1"W by 1"L it fits easily in the narrow fuselage. I hooked everything up and it workd great in a bench test. The reasons I deducted 1 star: 1. You have to solder the motor leads to the micro tabs on the receiver board. And 2. The wires for the motor and battery exit the board in line with the servo gears. So far, for the price this receiver is worth what it cost.

Bound to the nx8, easy to solder the motor wires, responsive servos, and very light and small. Worth the price. Pretty good range, the plane goes out of sight before I lose control. However, the servos are weak and bind up really easily. I put this into a hobby zone champ airframe and the foam hinges for the elevator were enough resistance to bind the servo on full down. After some fiddling, I do believe I have resolved the issue.~6 month Update:I have purchased 9 of these receivers. 4 of the 244 and 5 of the 144. They are excellent receivers. The only complaint I have with them is the 244 needs the hinges to be as little resistance as possible so they don’t bind up. They have the torque to be sufficient in any ultra micro plane weighing less than about 2oz. The 144 is excellent as well. I’ve used those in micro sail planes, rc conversion of free flight kits and put into discontinued planes. Definitely my go-to for micro plane builds.

This is my husband's "go to" receiver for RC airplanes. He noted recently, however, that the board layout varies from receiver to receiver. Interesting. Doesn't affect functionality, but it doe affect mounting to the fuselage if you have a standard way of doing so.