UoYu 1 Acrylic Cutter and 11 Pcs Blade Set, Multi-Use Cutter with Cutting Blade

I had some clear acrylic panels that I wanted to cut to size to build something different with and this little knife did the job. It's along the same lines as a glass cutter in terms of difficulty to use. If you are careful and apply the proper pressure, you can cut a straight line. I'm not very good at either but I managed to get my cuts done properly and my project turned out great.

I do a lot of construction with EPVC board and had been using an xacto knife to cut pieces. Too much pressure and the blade snaps; too little and it takes forever to cut 1/4 inch sheet.With this tool it's easy to score the line, then follow it reliably without also holding a ruler - so much less complicated. Plus it makes quick work of the cutting so it's a lot less effort.

If you have ever cut glass then you already know how to cut acrylic sheets because it uses the same process.1. Clamp down a straight edge over the acrylic sheet2. Score the acrylic sheet3. Put the acrylic sheet along the edge of a table or counter and snap down on the part hanging off the edgeI suppose you could cut right through the acrylic sheet if it is thin enough; however I normally work with ¼ and 3/8 inch sheets and that just isn’t being realistic.Now keeping that all in mind this cutter scored the sheet just fine. It does have a non-standard way of connecting up the blades and the blades do not retract after being attached. At the same time it does do the job it should and that is scoring the acrylic and comes with extra blades.I needed a quick replacement to an old acrylic cutter that was damaged so I picked this one up. It was cheap, came with extra blades and does the job. Is it for someone who is going to be cutting a hundred sheets a day; probably not, but if you are going to be cutting a couple a week and don’t want to spend allot of money then this does the job.

We installed acrylic panels on the outside of a screen room for the winter. We needed to cut a couple of the sheets in half. It worked perfect

This product is so bad, the bladencannot retract, and the handle falls apart with minimal force. This product is a hazard. Do not buy.

The yellow end piece of the handle would fall apart when pressure is applied. Also, the very sharp cutter blade can not be retracted into the handle. and always pose as a safety hazard.

It does a good work when I cut acrylic

Bueno