⚡ Upgrade your Ender 3 experience—print smarter, not harder!
This Creativity Full Assembled Ender 3 Hotend Upgraded Kit is a ready-to-install, high-quality replacement part compatible with Ender-3 series printers. Featuring a stainless steel nozzle throat that withstands temperatures up to 260°C, it ensures durable, precise printing. The kit includes 4 nozzles and a silicone sleeve, offering excellent value and convenience for both beginners and seasoned 3D printing enthusiasts.
D**L
Great Value Easy Replacement
Great value easy install
J**E
Good value for the price.
Easy to install, works great.
M**K
Works great, watch your wiring
Works great, watch your wiring. The quality is first rate and is just want I needed for my ender 3, a great price as well. I suggest that you take photos of your original wiring with your cell phone before disassembly as there is what appears to be an extra wire on the new Hotend that will be confusing as to where things go on the new one. Take photos of the wiring on the old Hotend and where they connect on the circuit board. I followed what was an extra wire on the new Hotend and compared it to my old one and plugged it in the location I thought it belonged in. If you pay attention and look at your photos as I suggest its obvious to figure it out. Overall though a great replacement.
A**N
Good replacement
This is a good replacement for your stock Ender hotend if your NOT looking to upgrade but just to get your printer running.It's easy to install as it is a direct replacement and no cable splicing or anything crazy is necessary. It provides the same print quality as the stock hot end and is a good bit cheaper than most alternatives.Only downfall was out of the box there was some heat creep causing my prints to fail after a certain point.(Loosening the two screws on the bottom of the hot end by the nozzle and re rightining them *snug not over torqued* seemed to resolve the heat creep issue.)
A**R
Great peice of Work
It was great, and works great. Pretty easy to install as well.
J**R
Nice buy!
Great upgrade! Yellow and blue wire are for the fan, just in case. No instructions which would have been nice, but we figured it out.
P**P
Do not use this part if a different 'Hot Head' is on your machine!
this is a direct replacement for the original printing head. The mount to the X axis traveler if altered with another 3D printed part fore a different printing head will cause a crash condition.
L**Z
Drop in and print.
Overall easy set up. I did end up breaking my fan .. again.. and had to order a new one but overall, the new hot end has done well, and the additional nozzles were a nice bonus.
Trustpilot
5 days ago
1 month ago
